A leaking mixing valve on a Rockville gas water heater had been patched as a short-term fix. Our technician came back and replaced the valve for good, then checked that it worked and was no longer leaking.

The problem
The mixing valve on the water piping in front of the water heater in the utility room had been leaking. An earlier visit stopped the drip as a short-term repair, and the valve still needed to be replaced.
What our technician found
A mixing valve, also called a tempering valve, blends some cold water into the hot water leaving the heater so the water at the taps is not scalding. When its internal seals or its connections wear out, it starts to weep at the joints. A short-term fix can stop the drip, but a valve that has started leaking usually needs to be replaced.
What we did
- Removed the old mixing valve from the piping in front of the water heater.
- Installed a new mixing valve.
- Checked that it worked and that there was no more leak.
Parts used
- Water heater mixing valve
The result
The new mixing valve was working, and there was no more leak at the end of the visit.
Tips for Rockville homeowners
- If you see water at the piping on top of or in front of your water heater, check where it is coming from. A valve or fitting is a much cheaper fix than a new heater.
- Know where the cold water shutoff above your water heater is. Closing it stops a leak in the heater's piping until a plumber arrives.
- If the hot water at your taps suddenly gets hotter or cooler after a repair, the mixing valve may need adjusting.

