A Darnestown basement was backing up into the toilet and shower. Our technician freed the jammed sewage injector pump, cleaned out its pit, and rebuilt the discharge connections with a new check valve and shutoff.


The problem
The homeowner called about a backup in the basement that affected the toilet and the shower. The pump turned out to be a sewage injector pump, a sealed pit with a pump that lifts waste up to the main sewer line.
What our technician found
Basement bathrooms that sit below the main sewer line need a sewage injector (ejector) pump. When the pump jams, usually from wipes or debris, waste can't be lifted out of the pit, and the basement toilet and shower start to back up. The check valve on the pump's discharge pipe keeps pumped waste from flowing back into the pit, so it matters as much as the pump itself.
What we did
- Opened the sewage injector pit in the basement.
- Freed the jammed injector pump.
- Cleaned out the pit.
- Installed a new check valve with a shutoff valve on the pump's discharge line.
- Reconnected the discharge piping with new rubber couplings and a new male adapter.
Parts used
- Check valve with shutoff valve
- 2-inch and 3-inch rubber pipe couplings
- 2-inch male adapter
The result
The injector pump was freed and the pit cleaned. On the same visit our technician also cleared the main sewer line from the outside cleanout. He then ran plenty of water and flushed the toilet several times, and there was no more backup.
Tips for Darnestown homeowners
- Only toilet paper should go into a toilet that drains to an injector pump. Wipes, even 'flushable' ones, are the most common cause of a jammed pump.
- If a basement toilet or shower backs up, stop using all the basement fixtures until the pump is checked.
- A shutoff valve above the check valve lets a plumber service the pump without draining the whole discharge line onto the floor.
- Listen for your injector pump. If it runs nonstop, hums without pumping, or never seems to run, call a plumber before it backs up.

